8-Channel Signal Relay Module

brand: SainSmart 2 reviews SKU: 101-70-114 Variants ID: 45099811092
  • 8 Signal relay
  • Interface definition:
  • IN(x): High level. Low level cut-off
  • This item has been assembled,
  • Led indicator for each relay.
  • FR-4 Fiber glass PCB ( Double Layer ).
  • PCB thickness: 1.6mm.
  • Size: 103 x 51 x 16 mm .
  • Power Supply: 5V DC / 70mA (relay all ON).


Input control signal voltage:  

  • 0V - 0.5V Low stage (relay is OFF),
  • 0.5V - 2.5V (unknown state).
  • 2.5V - 5V High state (relay is ON).


Input control signal high state current:

  • 2.5V: 0.1mA
  • 3.3V: 0.18mA
  • 5V: 0.35mA                 
  • Voltage: 5V DC.
  • Current: 8.3mA.
  • Resistance: 2880 ohm +-10%.


Contact Rating:

  • Contact Resistance: <0.1 ohm.
  • Contact Capacity: 125V AC / 1A,  30V DC / 2 A.
Customer Reviews
4.0 Based on 2 Reviews
Write a Review Ask a Question
  • Reviews
  • Questions

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
Best value DPDT board out there

I use this in a remote controlled preamp. Each relay provides one stereo switch. Easy to drive from an Arduino. The only thing that's not ideal is that it powers up in a random state, but I think that's more down to how it's controlled, and not a flaw in the board, which simply sets the relay based on inputs. Easy to wire up, robust, no problems.

Not quite meets specs but still good

This relay board needs to have a resistor change to drive it from 3.3 volts reliably. Other than that, it is good to go with a Raspberry Pi. I replaced the 1k resistor with a 680 ohm and removed the 10k ohm resistor since the Raspberry has it's own pulldown resistors on the GPIO bus. I2c port expanders like the MPC 23017 also have pulldown resistors.