SHOPPING CART

X

Review of Genmitsu 3018-PROVer V2 CNC Router, Part 1

Posted by SainSmart on

Review of Genmitsu 3018-PROVer V2 CNC Router, Part 1

Written by Graham Bland. You can find me on the Facebook group SainSmart Genmitsu CNC Users Group  All comments, suggestions and corrections are welcome.   This is Genmitsu 3018-PROVer V2 CNC Router, currently availab...

View More

Customer Review: Jinsoku LC-40 Laser Engraver

Posted by SainSmart on

Customer Review: Jinsoku LC-40 Laser Engraver
With the Jinsoku LC-40, SainSmart has a new entry into the world of CNC lasers in its range. We took a closer look at the model and compared it to our 3018-PRO DIY CNC milling machine, which had previously been upgraded with a laser. In terms of price, the two models are the same at around €400, as is the 5.5 W laser module used. Besides the obvious - the optics - there are also some other differences.

View More

Engraving Vinyl Records with 3018-PRO

Posted by SainSmart on

Engraving Vinyl Records with 3018-PRO

Written By Patrizio Virtuani   WARNING! Do not try to cut vinyl with a laser, the heat of the beam on the vinyl surface generates a very toxic gas, vinyl chloride, very dangerous if inhaled by man but also for the equ...

View More

It Won't Be Moving! Genmitsu Vacuum Table for 3018-PROVer

Posted by SainSmart on

It Won't Be Moving!  Genmitsu Vacuum Table for 3018-PROVer
A vacuum bed uses air pressure to push the stock down onto the bed by pumping out the air from underneath it, creating a partial vacuum. The resulting difference in air pressure applies a quite large clamping force evenly over the stock. Using the suggested vacuum pump (sold separately) a clamping force of ~12 lbs is exerted over every square inch of the surface. 85 kPA is also ~0.9kg per cm2. Let’s just say the stock is not moving unless you turn off the pump.

View More

Genmitsu Dust shoe for 52mm Spindle Motor

Posted by SainSmart on

Genmitsu Dust shoe for 52mm Spindle Motor

Written by Graham I am using this on my 3020-PRO MAX, It’s not so much a dust shoe for the 3020-PRO MAX, but a dust shoe for a 52mm diameter spindle motor, it really makes no difference on what machine your motor i...

View More

Scroll To Top